HOMAX Tex»Pro™ Texture System
Item #TP01/ea
Free Shipping
On All Orders
Description
TexPro is now available! Buy online and in-store at select PPG Paints and Home Depot locations.
Up to 70% faster1 and 60% lighter2 than a traditional hopper gun, Homax TexPro Texture System makes a tough job simple. With a lightweight, comfortable and innovative design, applying texture is now a breeze. Simply hook the sprayer up to an air compressor*, load the ready mix texture cartridge, and pull the trigger. Faster >> Lighter >> Better. A Simpler Texture System2.
View TexPro Sell Sheet (English)
View TexPro Sell Sheet (Spanish)
*sold separately
1Setup and cleanup time for HOMAX TEXPRO vs. hopper gun
2HOMAX TEXPRO vs. full hopper gun
Details
Directions
Reviews
Details
- Innovative alternative to hopper gun
- Comfort, balanced grip
- Easy, ready-to-use cartridges* makes jobs easy to tackle with one person
- Quick and easy prep and cleanup
- Delivers consistent, quality results
- Two texture formulas* air pressure settings and spray tip options enable a wide range of texture looks
- Applies light and heavy texture to interior walls and ceilings
- For use on indoor drywall
- Package contains:
- Homax TexPro Sprayer; Rear Gasket (2); Front Nozzle Gasket (2); Air Shut-Off Valve; 3 Spray Tips (small, medium, large); Rubber Spray Tip Cover; Cartridge Seal Cutting Tool; Cleaning Brush; Small Storage Case with Spare Hinge Pins; Instruction Manual
- Only for use with HOMAX TEXPRO Texture Cartridges*
*sold separately
Directions
TexPro Texture System operates differently than a typical hopper gun–take time to understand how it works and practice using this new system before you attempt your first job.
1.Set up sprayer- Install front gasket in front cap; install rear gasket in rear cap; select & install spray tip; connect air shut-off valve & set to off position
- See user manual for step-by-step instruction with photos.
- Select light or heavy texture for desired appearance & job conditions
- Cut cartridge tip; puncture seal inside tip
- With air shut-off valve “off”, compressor power disconnected, and front cap latched closed – load cartridge: Open rear cap. Insert prepared cartridge.
- Use a compressor (sold separately) that delivers 2.6 scfm or greater; higher compressor pressure = finer splatter patterns; lower compressor pressure = heavier splatter
- Put on protective wear. Protect surroundings from overspray. Prepare surface for texture following instructions on texture cartridge.
- Start compressor and turn air shut-off valve to on position. Begin spraying holding sprayer tip 4 feet from wall. Control size of texture pattern by a choice of spray tip, compressor output pressure, and sprayer regulator pressure.
- Release trigger. After releasing trigger, spray will continue from nozzle for 3 seconds. Ensure sprayer is pointed at surface until spray completely stops.
- After use, disconnect power to air compressor and remove components. Clean each component. Allow parts to dry before replacing in case.
WARNING: BEFORE HANDLING THE TEXTURE SPRAYER OR WHEN YOU STOP SPRAYING OR ARE REMOVING ANY EQUIPMENT PARTS:
1. SHUT OFF AIR SOURCE AT AIR COMPRESSOR.
2. DISCONNECT AIR COMPRESSOR POWER SOURCE