Aerosol Wall Texture, Knockdown, 10 oz

Directions

Homax^® Knockdown Texture is the fastest way to patch “knockdown” drywall textures. To achieve the best results, please read the following directions carefully before you begin your wall repair project.
 
WARNING: Cancer - www.P65Warnings.ca.gov
 
VENTILATE AREA WELL. PROTECT SURROUNDING AREA FROM OVERSPRAY. DO NOT SPRAY ON CLOTHING, FURNITURE OR CARPET.

• Water-based, use warm water for cleanup.
• Sprays best between 68˚ F and 72˚ F.
 
DIRECTIONS FOR USE: MAKE ANY NECESSARY WALL REPAIRS BEFORE APPLYING. FOR BEST RESULTS, PRIME/SEAL AREA BEFORE AND AFTER APPLYING TEXTURE.

1. SHAKE CAN vigorously FOR ONE MINUTE prior to use.
2. TWIST OFF safety tab from nozzle.
3. Always practice spraying on cardboard or scrap drywall to determine preferred pattern. Pointing away from face, adjust dial to desired pattern:
– STRAIGHT UP for LIGHT KNOCKDOWN.
– COUNTER CLOCKWISE for HEAVY KNOCKDOWN.
4. SPRAY using a circular motion. For a heavier knockdown pattern, spray in short bursts to build up texture. Shake can occasionally throughout use.
5. Allow texture to dry for 4 to 8 minutes, then knockdown. Use knockdown or 6-8” drywall knife, wet blade, hold nearly parallel to surface, and draw across texture applying little to no pressure. DRY TIME: Allow to dry 2-5 hours before painting (depending on heaviness of pattern).
6. TO STORE: To store, clear nozzle by turning can upside down and spraying until texture is cleared.
 
PRECAUTIONS AND FIRST AID: Sanding and grinding dusts may be harmful if inhaled. This product contains crystalline silica which can cause lung cancer or silicosis. The risk of cancer depends on the duration and level of exposure to dust from sanding surfaces or mist from spray applications. The product may not be stable under certain conditions of storage or use: high temperature/pressure hazard. In a fire or if heated, a pressure increase will occur and the container may burst or explode. Keep away from heat, sparks and flame. Keep away from flames, such as a pilot light, and any object that sparks, such as an electric motor. Do not puncture or incinerate container. Do not expose to heat or store at temperatures above 120°F. Do not breathe vapor or mist. Do not swallow. Do not get on skin or clothing. Avoid contact with eyes. Keep container tightly closed and sealed until ready for use. Wash thoroughly after handling. Provide fresh air ventilation during and after application and drying. Avoid the inhalation of dust, particulates, spray or mist arising from the application of this preparation. Use personal protective equipment as required. FIRST AID: If swallowed, rinse mouth with water (only if the person is conscious). Call physician immediately. Do not induce vomiting unless directed to do so by medical personnel. If in eyes, rinse with water for 15 minutes. Check for and remove any contact lenses. If on skin, rinse well with water. Wash with soap and water. Get medical attention if irritation develops. If inhaled, remove to fresh air. If experiencing respiratory symptoms call a POISON CENTER or doctor/physician. Contains: proprietary pigment (not available); water (7732-18-5); dimethyl ether (115-10-6); proprietary binder (not available); proprietary phosphoric acid ester (not available); crystalline silica, respirable powder (<10 microns) (14808-60-7). Keep out of the reach of children. For workplace use, an MSDS is available from your retailer or by calling (412) 492-5555. EMERGENCY SPILL INFORMATION: (412) 434-4515 (U.S.). I

WARNING: Cancer – www.P65Warnings.ca.gov.