0 0 6.79 New USD Homax PPG Arch Coatings Paneling & Molding Adhesive (LN-710) Model: 407682 Product ID: 407682 This fast-bonding adhesive is like an extra set of hands, providing a sure hold, precision placement and less nailing. Ten minutes of working time and an impact-resistant bond help make it an excellent choice for installing crown molding and other paneling and trim.Recommended for: installing crown molding, corkboard, paneling, wood molding, foil, wainscot and insulation board. 407682

Paneling & Molding Adhesive (LN-710)

Item #407682


$6.79

Free Shipping

On All Orders

Quantity Discounts

4-8 $5.99 | 9+ $3.99 | High Volume


Description

This fast-bonding adhesive is like an extra set of hands, providing a sure hold, precision placement and less nailing. Ten minutes of working time and an impact-resistant bond help make it an excellent choice for installing crown molding and other paneling and trim.

Recommended for: installing crown molding, corkboard, paneling, wood molding, foil, wainscot and insulation board.

Details

Directions

Reviews

Details

Key Features
  • Retains precise placement
  • Reduces nailing
  • Impact resistant
  • Contributes to LEED® certification
  • Contributes toward NAHB National Green Building Standard™ certification of the structure
  • Certified to the GREENGUARD Gold standard as a low emitting material

Recommended For:
Installing crown molding, corkboard, paneling, wood molding, foil, wainscot and insulation board.

NOT Recommended For:
Uses other than paneling and molding installations, use between two non-porous surfaces, or exterior use.

Coverage
Using a 1/4" (.64 cm) bead: 10 fl. oz. cartridge covers 30 lineal ft.

Max VOC
43 GPL

This product cannot ship to Hawaii or Alaska.

Directions

Surface Preparation
All panels must be separated and conditioned to room temperature for 48 hours prior to installation. Preparation: Surfaces must be clean, dry and structurally sound before applying fast-bonding adhesive. Cut and pre-fit materials prior to installation.

Product Application
Place cartridge in gun, cut nozzle and puncture inner seal with nail or wire. Apply 1/4" bead of fast-bonding adhesive around the perimeter of parts to be bonded. Adhere materials within 20 minutes of gunning this fast-bonding adhesive. Warped materials may require bracing and/or nailing. Instant-grab method: Paneling — Apply 1/4" bead of fast-bonding adhesive approximately 1" from edge of panel around the perimeter. Apply two zig-zag 1/4" beads in the middle of the panel. Press panel firmly into place. Remove panel from wall for one minute. Rejoin panel to wall. Molding — Apply 1/4" zig-zag bead of fast-bonding adhesive to back of molding. Press molding firmly into place. Starting at one end, nail every 12".

Cleanup
If this fast-bonding adhesive is wet, use water promptly. If the fast-bonding adhesive has dried, scrape it away, then remove residue using a cloth dampened with mineral spirits.

Reviews