0 0 12.45 New USD Homax PPG Arch Coatings Mirror Adhesive, 10 oz (LN-730) Model: 407684 Product ID: 407684 Liquid Nails® Mirror Adhesive (LN-730) is a high solids, moisture-curing adhesive designed for use in conjunction with mechanical fastening systems for the installation of mirrors to walls. The product adheres to most common construction materials and cures rapidly, reducing the time required for bracing or taping of mirrors and decreasing installation time. LN-730 is non-flammable and is nearly odorless, making this adhesive ideal for installations in occupied areas. This product meets all air quality regulations and also meets the requirements of the US Green Building council LEED and the National Association of Home Builders Residential Green Building programs. 407684

Mirror Adhesive, 10 oz (LN-730)

Item #407684


$12.45

Free Shipping

On All Orders

Quantity Discounts

4-8 $10.95 | 9+ $8.95 | High Volume


Description

Liquid Nails® Mirror Adhesive (LN-730) is a high solids, moisture-curing adhesive designed for use in conjunction with mechanical fastening systems for the installation of mirrors to walls. The product adheres to most common construction materials and cures rapidly, reducing the time required for bracing or taping of mirrors and decreasing installation time. LN-730 is non-flammable and is nearly odorless, making this adhesive ideal for installations in occupied areas. This product meets all air quality regulations and also meets the requirements of the US Green Building council LEED and the National Association of Home Builders Residential Green Building programs.


Details

Directions

Reviews

Details

Recommended For bonding mirrors to:

  • Concrete
  • Painted surfaces
  • Drywall
  • Wood
  • Metal
  • Plaster

 

Not Recommended For:

  • Uses other than mirror installation
  • Ceiling applications
  • Wallpapered surfaces

 

NOTE: THIS PRODUCT REQUIRES THE USE OF A PERMANENT MECHANICAL FASTENING SYSTEM. DO NOT INSTALL MIRRORS WITHOUT A PERMANENT MECHANICAL FASTENING SYSTEM.
Please research all installation instructions and read entire label for safety, health & environmental information prior to use.

Product Advantages:

  • Will not damage reflective backing
  • Strong vertical hold
  • Heat & steam resistant
  • Permanent bond
  • Stays flexible
  • Interior
  • 100% Satisfaction Guaranteed

This product cannot ship to Hawaii or Alaska.

Directions

Surface preparation:
Surfaces must be clean, dry, and structurally sound. Painted surfaces must be lightly sanded with coarse sandpaper.

Applying The Product:
Insert tube into caulking gun, cut nozzle and puncture inner seal. Apply adhesive in 3/8" diameter beads running the full length of the mirror. Beads should be 5 to 6 inches apart. Press mirror into place within 15 minutes and fasten with permanent support system. Tape or brace top of mirror to hold in place if necessary, depending on support system used. Adhesive will set in approximately 24 hours. Edges may be sealed immediately after application, if desired. Coverage: 7 square feet of mirror per cartridge.

Clean-up:
Clean up wet adhesive by wiping with paper towel, followed by wipe with towel and mineral spirits. Dried adhesive can be removed by scraping.

Disposal:
Place empty containers in normal refuse for disposal. Remove residual product from the container, allow product to dry, and dispose of in conjunction with normal household waste. Contact your sanitation department or household hazardous waste coordinator for information concerning possible re-use of unused caulks and sealants.

 WARNING: Reproductive Harm - www.P65Warnings.ca.gov.

Reviews