0 0 6.79 New USD Homax PPG Arch Coatings Interior Projects Adhesive, 10 OZ (LN-704) Model: 407680 Product ID: 407680 This high-strength, low-odor, latex construction adhesive features excellent flexibility, water resistance and long-term holding power when set. It's a versatile and convenient indoor construction adhesive that bridges gaps up to 3/8" and cleans up with water when wet.Recommended for: foamboard, drywall, molding, paneling, plywood/hardboard, masonry/concrete, foamback tub surrounds, corkboard, ceramic tile repair, insulation board, and furring strips. 407680

Interior Projects Adhesive, 10 OZ (LN-704)

Item #407680


$6.79

Free Shipping

On All Orders

Quantity Discounts

4-8 $5.99 | 9+ $3.99 | High Volume


Description

This high-strength, low-odor, latex construction adhesive features excellent flexibility, water resistance and long-term holding power when set. It's a versatile and convenient indoor construction adhesive that bridges gaps up to 3/8" and cleans up with water when wet.

Recommended for: foamboard, drywall, molding, paneling, plywood/hardboard, masonry/concrete, foamback tub surrounds, corkboard, ceramic tile repair, insulation board, and furring strips.

Details

Directions

Reviews

Details

Key Features
  • Will not attack foam insulation
  • VOC-compliant
  • No harmful fumes
  • Water cleanup
  • Contributes to LEED® certification
  • GREENGUARD Gold Certification
  • Contributes toward NAHB National Green Building Standard™ certification of the structure

Recommended For:
Foamboard, drywall, molding, paneling, plywood/hardboard, masonry/concrete, foamback tub surrounds, corkboard, ceramic tile repair, insulation board, and furring strips.

NOT Recommended For:
Outdoor use or for application of mirrors, marble, ceiling tile, wood flooring, underwater use, or most tub surrounds (with the exception of foamback tub surrounds). Not recommended for bonding foamback tub surrounds directly to ceramic tile.

Coverage
Using a 1/4" (.64 cm) bead: 10 fl. oz. cartridge covers 32 lineal ft.

Max VOC
35 GPL

Specifications
ASTM C 557

This product cannot ship to Hawaii or Alaska.

Directions

Surface Preparation
Make sure that all surfaces are clean, dry and structurally sound before construction adhesive is applied. Do not apply to moist concrete or masonry. Note: One surface must be porous.

Product Application
Cut and pre-fit materials prior to installation. Insert tube into caulk gun. Cut nozzle to desired bead size marked on nozzle. Puncture inner seal with nail or wire. Construction adhesive should be gunned at a room temperature of 60°F or higher. Adhere all materials before construction adhesive skins over.

Bonding Material To Furring Strips Or Studs
Apply a zig-zag 1/4" bead of construction adhesive to each strip or stud to be covered by material. Position materials so edges meet at stud center. Press firmly into place against wall. Finishing nails are required.

Bonding Foamboard, Foamback Tub Surrounds, Panels, Corkboard, etc. To Flat Surfaces
Apply 1/4" beads of construction adhesive in vertical zig-zag pattern over entire substrate surface. Construction adhesive beads should be a maximum of 12" apart and within 1-1/2" of all edges. Bracing may be necessary until adhesive has set.

Drying Time
Working time up to 30 minutes. Dries in 24 hours. Fully cured in 28 days.

Cleanup
If the construction adhesive is wet, use water. If the construction adhesive has dried, use mineral spirits.

Reviews