0 0 24.99 New USD Homax PPG Arch Coatings Fiberglass RPP Adhesive, 1 GL (FRP-310) Model: 407655 Product ID: 407655 This strong-bonding, latex-based wall adhesive is specifically formulated for bonding Fiberglass Reinforced Panels (FRP).  407655

Fiberglass RPP Adhesive, 1 GL (FRP-310)

Item #407655


$24.99

Free Shipping

On All Orders

Quantity Discounts

4-8 $22.99 | 9+ $19.99 | High Volume


Description

This strong-bonding, latex-based wall adhesive is specifically formulated for bonding Fiberglass Reinforced Panels (FRP). 


Details

Directions

Reviews

Details

Key Features
  • VOC-compliant
  • Strong bond
  • Easy water cleanup
  • Will not attack foam insulation
  • Contributes to LEED® certification

Recommended For:
Bonding FRP to cured concrete, wood, drywall, concrete backer board, greenboard, foamboard and NRP panels (non-reinforced).

NOT Recommended For:
Exterior use or for bonding to tileboard, painted surfaces or wallpaper. May stain marble or granite surfaces.

Coverage
3.5 Gal. can covers 175 sq. ft. 1 Gal. can covers 50 sq. ft. 1 Quart can covers 12 sq. ft.

Max VOC
28 GPL

Specifications
ASTM C-557

This product cannot ship to Hawaii or Alaska.

Directions

Surface Preparation
For best results, wall adhesive and substrates should be between 50° and 90°F. Surfaces must be structurally sound and dry, free of grease, dirt, dust, wallpaper, paint or anything that would interfere with a bond. Level any high spots and fill all cracks and holes with appropriate fillers.

Product Application
Cut and pre-fit FRP panels. Spread wall adhesive with the recommended trowel over the entire back of the FRP panel. As soon as wall adhesive is spread over entire panel and before wall adhesive skins over (within 45 minutes), set panel in position and press against wall. Press panel firmly into place, working from the center to the edges until full contact has been made. Bracing may be required if walls or panels are not completely straight.

For Application Over Concrete
Concrete surfaces need to be dry and completely cured before applying this wall adhesive. When installing FRP panels over below-grade concrete where moisture can penetrate, you must first attach furring strips to the concrete block and then attach a solid surface, such as wood or drywall, to those furring strips. Then continue with standard FRP application.

For Channel Moldings, Permanent Fasteners and Panel Spacings
Follow FRP panel manufacturer's specifications.

Drying Time
Working time up to forty-five minutes. Very warm, dry conditions will decrease working time. Full cure within one week.

Cleanup
If the wall adhesive is wet, use water. If the wall adhesive has dried, use mineral spirits.

Reviews