0 Cart
0 0 9.44 New USD Homax PPG Arch Coatings Penetrating Grout Sealer, 22oz Spray Model: 9324 Product ID: 9324 Tile Guard® Penetrating Grout Sealer seals and protects grout against stains from water and oil-based liquids. Penetrating below the surface, it provides stain protection while also allowing moisture to escape so it can be used 2 weeks after grouting. 9324
Homax / Patch & Repair / Tile and Grout / Penetrating Grout Sealer, 22oz Spray

Penetrating Grout Sealer, 22oz Spray

Item #9324

Penetrating Grout Sealer, 22oz Spray
Penetrating Grout Sealer, 22oz Spray

Description

Homax® Tile Guard® Penetrating Grout Sealer seals and protects grout against stains from water and oil-based liquids. Penetrating below the surface, it provides stain protection while also allowing moisture to escape so it can be used 2 weeks after grouting.

Details

Directions

Reviews

Details

Homax® Tile Guard® Penetrating Grout Sealer seals and protects interior and exterior sanded or unsanded grout against stains from water and oil-based liquids. Penetrating below the surface, it provides stain protection while also allowing moisture to escape so it can be used 2 weeks after grouting. 

Coverage: Approximately 50 to 150 sq. ft. per pint for one coat, depending on porosity, texture, temperature, humidity and method of application.

For use on these surfaces:

  • Interior and exterior sanded grout with natural stone, masonry and tile surfaces.
  • Interior and exterior unsanded grout with natural stone, masonry and tile surfaces.

Directions

  1. Read all directions and warnings on package before using.
  2. Be sure grout is dry before sealing; wait 2 weeks after grouting to seal.
  3. Ensure that surface is clean and dry; existing sealers and coatings should be removed prior to coating.
  4. Surface temperature should be between 50°F and 80°F when sealer is applied. Sealer should not have contact with any non-recommended surface; (if this happens and sealer dries to create a white film, scrub surface with water and a white nylon pad.) Not to be used on food preparation surfaces.
  5. Apply 1 to 3 coats of Tile Guard® Penetrating Grout Sealer. Wipe up excess sealer where pools remain.
  6. Completely wipe surface dry, 3 to 5 minutes after each coat is applied.
  7. Allow 1 hour drying time between coats.
  8. After 2 hours, conduct a test to determine if surface is completely sealed by applying water droplets to the surface. If water is absorbed, apply an additional coat; wait 2 hours and repeat test.
  9. Surface is ready for traffic in 2 hours. Keep area dry for at least 12 hours; cures completely in 24 hours.
  10. Clean applicators with water after each use.

Safety Recommendations

  • KEEP OUT OF REACH OF CHILDREN
  • Contains Siloxanes. May cause eye and skin irritation.
  • Avoid contact with skin and eyes.
  • Do not take internally.

First Aid

In case of eye contact, immediately flush eyes with water for 15 minutes. Get medical attention if irritation persists. If swallowed, drink 2-3 large glasses of water and get medical attention immediately. If on skin, rinse thoroughly with water.

Reviews