Splash Guards

Splash Guards

Splash Guards

Instructions

Splash Guard


  1. Thoroughly clean tub and wall areas prior to application. Surface must be free of all soap film or residue. As a final preparation, use rubbing alcohol to remove soap and cleaner residue. Wipe area completely dry. Position Splash Guard in place and mark with a pencil.
  2. There is one left and one right sided Splash Guard. To determine which one to use, note that the curtain clip should only be visible from inside the tub. From outside the tub you should only see the smooth surface of the Splash Guard.
  3. If wall slants away from tub, place guard on flat surface and press on corrugation until the Splash Guard conforms to the wall angle. If wall slants toward the tub, compress guard to conform to the wall angle.
  4. Remove backing paper. Press firmly into place making contact with wall and tub at the same time. Extreme irregularities in wall or tub may require caulk.
  5. To secure shower curtain, hold the are of curtain closest to Splash Guard and gently slide the edge under the clip which rests on the side of Splash Guard facing the inside of tub.

Splash Guard Deluxe


  1. The area to which adhesive will bond must be thoroughly cleaned with household rubbing alcohol.
  2. To determine the installation point, locate the point on the horizontal surface of the tub wall, avoiding any vertical grout lines.
  3. Bend the anchor strip at the score. The longer end of the strip will be attached vertically to the wall at the relative position established in Step 2. Remove any excess caulk from the tub/wall joint that would interfere with the bonding of the anchor strip. Remove the plastic release film from the longer portion of the anchor strip, and beginning from bottom up, press it to the wall. The crease formed by bending at the score should be pushed into the tub/wall joint as far as possible before adhering rest of strip to wall.
  4. Remove the remaining release paper from the shorter leg of the strip and press adhesive firmly to tub.
  5. Attach the Splash Guard to the wall anchor strip by sliding it on from the top down. Splash Guard can be easily removed for cleaning.
  6. The shower may be used immediately after installation.