Instructions
Follow Carefully for Proper Adhesion:
Surface Preparation: Remove loose, protruding, or mildewed caulk. Thoroughly clean surface of tub and floor with an all-purpose cleaner; rinse clean. Use rubbing alcohol for final cleaning of surfaces to which Sealer Trim will bond. Allow surfaces to dry thoroughly.
Application:
- Measure the length of the tub to be covered and cut Sealer Trim to that length.
- Pre-bend Sealer Trim by folding it at the score line to form a 90° angle. Maintain fold during installation.
- Position the strip so that the wider portion is against the tub and the narrower portion is on the floor. Peel the first few inches of backing paper and begin to press the folded strip at one corner into the joint where the tub meets the floor. Avoid stretching product during installation. Pressing the strip firmly against both tub and floor, continue to peel the backing paper along the length of the surface.
- After installation, run your fingers firmly over all lengths to ensure good adhesion and watertight seal. Do not use tub or shower for 6 hours following installation.