Instructions
Surface Preparation: Remove loose, protruding, or mildewed caulk. Thoroughly clean surface of tub and wall with an all-purpose cleaner, paying special attention to faucet wall and below soap dish; rinse clean. Use rubbing alcohol for final cleaning of surfaces to which Sealer Trim will bond. Allow surfaces to dry thoroughly.
Application to tub and wall:
- Measure the long dimension of the tub and cut Sealer Trim to that length. (Total application will be made in three strips.)
- Pre-bend Sealer Trim by folding it at the score line to form a 90° angle. Maintain fold during installation.
- Peel the first few inches of backing paper and begin to press the folded strip at one corner into the joint where the tub meets the wall. Avoid stretching product during installation. Pressing the strip firmly against both tub and wall, continue to peel the backing paper along the length of the wall.
- Measure the short side lengths of the tub and apply trim the same way. At the corners, overlap the bottom half of the strip. You may leave it this way or miter (45° angle) the corners by cutting through both bottom layers.
- After installing all three strips, run your fingers firmly over all lengths to ensure good adhesion and watertight seal. Do not use shower or tub for 6 hours following installation.