Instructions
- Remove excess grease with solvent and excess rust with wire brush.
- Mix 1 part of Jasco Metal Etch to 3 parts water.
- Allow the compound to remain on the metal surface for about 1 minute.
- Rinse off with clear water or wipe surface with rags.
- On heavily rusted areas, use only 2 parts water to 1 part Metal Etch.
- Make sure surface is dry, then paint.
Storage: Close cap tightly and store in upright position after each use and before transporting.
Warnings:
- Irritant: Contains Phosphoric Acid
- Avoid contact with skin. Wash with cold water and contact physician if irritation persists.
- In case of contact with eyes, flush with cold water and call physician immediately.
- If swallowed, call physician immediately. Do not induce vomiting.
- Use with adequate ventilation.
- Keep out of reach of children.